Preset And All Data Reset - Mitsubishi Electric EMU4-FD1-MB User Manual

Preset and all data reset

You can reset all the integrated measured values or some of them to zero. (such as electric energy, operating time, etc.)
･ The integrated measured values you can reset to zero are as follows:
Electric energy (consumption, regeneration), Reactive energy, Periodic energy, Pulse count, Equivalent CO
- Preset (Data reset of selected value)
・In each integrated value display of operating mode, press both
two seconds to transition to preset mode.
・Preset procedure is as follows:
Operation of preset display
・ Press or
+ / PHASE
･ Press for the setting digit (flashing digit) to shift to lower.
SET
･ Press for the setting digit (flashing digit) to shift to upper.
DISP
・ Press at the lowest digit to transition to preset confirmation display as below.
SET
・ In preset confirmation display, choose "yES" to reset value, then back to the integrated value display.
・ In preset confirmation display, choose "no" to cancel resetting value, then back to the integrated value display.
・ Preset display transition example (Electric energy (consumption))
- All data reset
･ In each integrated value display of operating mode, press both
seconds to transition to all-data-reset display as below.
･ In all-data-reset display, choose "yES" to reset all the integrated values to zero, then back to the integrated value display.
･ In all-data-reset display, choose "no" to cancel resetting, then back to the integrated value display.
･ All data reset display transition
Integrated
value display
to choose the value at flashing digit.
- / RESET
+ -
+
for 2 sec
+
SET
+
Press both at the same
time for 2 sec
SET
SET
+ / PHASE and
SET
DISP
DISP
SET
SET
and
SET + / PHASE
+
-
(56/71)
, Operation time
2
- / RESET at the same time for more than
SET
DISP
DISP
-
at the same time for more than two
SET
+