Unpacking The S530 System - Keithley S530 Administrative Manual

S530 Administrative Guide

Unpacking the S530 system

The Keithley field service engineer (FSE) is responsible for unpacking the S530 system cabinet and the
accessories (which is in a separate box). However, it is recommended that the customer moves the crate and the
accessories box to the area where the system is going to be used. Here is a list of tools needed for unpacking:
•
Standard screw driver
•
Socket wrench
•
Socket head: 19 millimeters (mm)
The following information will help you when you begin to unpack your system.The system is shipped in a wooden
crate (see Figure 2).
Figure 2: S530 system cabinet in shipping crate
Unpacking system components
Inspect the shock sensor located on the outside of the shipping box (see
shock condition, conduct a very thorough inspection of all components contained in the system cabinet. Also, check
the "TIP N TELL" indicator to ensure that the crate has not been tipped over (see
the shipping agent immediately. Carefully remove all system components from the crate. While unpacking, make
sure there is no component damage. Please reuse or recycle packaging materials in accordance with your local
requirements.
4
Figure 3). If the shock sensor indicates a
Figure 4). Report any damage to
PA-992 Rev. D / April 2012