Initial Equipment Startup; System Startup; Shut Down Using Acs - Keithley S530 Administrative Manual

S530 Administrative Guide
Figure 15: S530 PDU circuit breaker
On the front of the system, turn the POWER switch to the ON position. The POWER switch is located on the front
door of the cabinet (see
attempting to use the S530 system and any software.

Initial equipment startup

1. Check that all line cords for the system cabinet are connected to AC power.
2. Make sure that the circuit breaker on the PDU is in the ON position.
3. Press the power/standby button on the computer and monitor.
4. Set the power button on the front door of the system to the ON position (see

System startup

1. Make sure that the power switch on the PDU is set to on.
2. Set the power button on the front door of the system to the ON position.
3. If the computer has not started to boot, then open the front cabinet door and press the Power/STANDBY
switch on the host computer.
4. Wait for all the instruments to power up.
5. Login to your computer and start the KTE or ACS software.

Shut down using ACS

NOTE You must have administrator rights in ACS software in order to shut down the S530
system.
1. Double-click the Shutdown icon on the computer desktop. On the dialog box that opens, click Yes that you
want to Shutdown the S530 Tester.
NOTE The following message opens after you click Yes to Shutdown the S530 (see
16). You must wait until the Model 4200-SCS and the system computer shut down
before you press the power button on the system cabinet. It may take several minutes
for the system to shut down.
PA-992 Rev. D / April 2012
Figure 17). Make sure the system computer and monitor are also turned on before
Figure 17).
Figure
25