Function Access/Set - Status Keys - Toshiba TOSVERT-130G2+ Operation Manual

6.5

Function Access/Set - Status Keys

Note:
Each key (0-9) has three separate functions: numerical value, first function,
and second function. See Operating Panel (Section 6.1)
Key
MON
Toggles between the monitor and function mode.
Switches to the second function mode.
2ND
Used to initiate several functions (ie. JOG, Preset Run, Pattern Run).
NEXT
Displays the next item within the function. Also cycles through the inverter's
status codes.
Clears the display. Also clears inverter after a trip.
CLR
(Must press CLR/WRT to reset inverter after a trip)
Stores each piece of data into the inverters memory (file).
WRT
READ
"." is a decimal point.
.
"READ" displays the inverter's data contents for an individual function.
"0" is the numerical zero.
1st FUNCTION MODE:
FMAX
0
2nd FUNCTION MODE:
"1" is the numerical one.
1st FUNCTION MODE:
V/F
1
2nd FUNCTION MODE:
injection voltage, and DC voltage injection time.
"2" is the numerical two.
1st FUNCTION MODE:
ACC/DEC
2
2nd FUNCTION MODE:
"3" is the numerical three.
1st FUNCTION MODE:
UL/LL
2nd FUNCTION MODE:
3
"4" is the numerical four.
1st FUNCTION MODE:
2nd FUNCTION MODE:
OL
4
dynamic braking resistor is used.
Function
Selects the standard setting mode. Also sets the
maximum frequency (disabled during a run).
Sets the start-up frequency and run frequency.
Also sets the run frequency hysteresis.
Sets the voltage boost, auto torque boost, maxi-
mum voltage frequency, and V/F pattern.
Sets the DC injection starting frequency, DC
Sets the ACC/DEC time for ACC 1, 2 and DEC 1, 2.
Selects the ACC/DEC pattern for 1, 2.
Selects ACC/DEC 1 or 2.
Sets the multiply factor of display frequency scaler.
Sets upper and lower frequency limits.
Sets low speed detection output.
Selects speed reach selection output option.
Sets speed reach detection range and speed reach
reference frequency.
Sets overload detection level (% of rated current),
stall activation level, and also selects the overload
detection curve characteristics.
Sets the output voltage adjustment (% of input
voltage).
Selects the dynamic braking resistor option and the
OLr option.
Selects the auto deceleration option when no
6 - 5
TOSHIBA