First Function Parameters - Toshiba TOSVERT-130G2+ Operation Manual

TOSHIBA
6.7

First Function Parameters

Function Function
No. Name
- Frequency setting
Standard setting mode
0
Maximum frequency
Voltage boost
Auto torque boost
(voltage)
1 Max. voltage frequency
V/f pattern
Acceleration time #1
Deceleration time #1
Acc/Dec #1 pattern
2 Acceleration time #2
Deceleration time #2
Acc/Dec #2 pattern
Acc/Dec #1, #2 select
3 Upper limit frequency
Lower limit frequency
Overload detection
4 Stall protection
Overload detection curve
IV-ref. setting point #1
5 #1 output frequency
IV-ref. setting point #2
#2 output frequency
RR terminal priority
*
Adjustment
Display Range
0.1~400
1: 50Hz motor
2: 60Hz motor
3: Factory set (Reset to default)
(Always 0 display in this mode.)
30 to 400
0 to 30
0: Off
1: On
25 to 400
0: Constant torque
1: Variable torque
0.1 to 6000 (SEE NOTE #1 PG. 6-9)
0.1 to 6000
0: Linear
1: S-curve
2: C-curve
0.1 to 6000 (SEE NOTE #1 PG. 6-9)
0.1 to 6000
0: Linear
1: S-curve
2: C-curve
0: Acc/Dec #1
1: Acc/Dec #2
0 to Max. frequency
0 to upper limit frequency
10 to 100
10 to 150
0: STD-motor, No soft stall
1: STD-motor, Soft stall
2: VF-motor, No soft stall
3: VF-motor, Soft stall
0 to 100
0 to Max. frequency
0 to 100
0 to Max. frequency
0: IV terminal input "on"
1: RR terminal input "on"
This is the operating frequency setting parameter. It is located within the monitor
mode but is not a true first function parameter. It is used to set an operating
frequency by scrolling up or down the frequency range, using the "up" or "down"
keys until the desired frequency is reached, rather than by entering data for a
particular output frequency (see section 7.2 and 8.3).
Unit
* Hz
Hz
%
Hz
sec
sec
sec
sec
Hz
Hz
%
%
%
Hz
%
Hz
6 - 8
Factory Error Ref.
Set Message Page
0 8-6
3 8-21
80 8-21
3 8-21
0 8-21
60 8-21
0 8-21
10 8-21
10 8-21
0 8-21
10 8-21
10 8-21
8-21
0
0 8-21
80 8-21
0 8-21
100 8-22
150 8-22
0 8-22
20 8-23
0 8-23
100 8-23
80 8-23
0 8-23