Update Via Udp - ADF Web HD67038-2-A1 User Manual

Industrial Electronic Devices

UPDATE VIA UDP:

By pressing the "Update via
the device; and also the Firmware, if necessary. This by using the Ethernet port.
If you don't know the actual IP address of the device you have to use this procedure:
Turn OFF the device;
Put Dip2 of 'Dip-Switch A' in ON position;
Turn ON the device;
Connect the Ethernet cable;
Insert the IP "192.168.2.205";
Press the "Ping" button, "Device Found!" must appear;
Press the "Next" button;
Select which operations you want to do;
Press the "Execute update
When all the operations are "OK" turn OFF the Device;
Put Dip2 of 'Dip-Switch A' in OFF position;
Turn ON the device.
If you know the actual IP address of the device, you have to use this procedure:
Turn ON the Device with the Ethernet cable inserted;
Insert the actual IP of the Converter;
Press the "Ping" button, must appear "Device Found!";
Press the "Next" button;
Select which operations you want to do;
Press the "Execute update
When all the operations are "OK" the device automatically goes at Normal Mode.
At this point the configuration/firmware on the device is correctly updated.
ADFweb.com S.r.l.
UDP" button, it is possible to load the created configuration into
firmware" button to start the upload;
firmware" button to start the upload;
User Manual RS485 / RS232 / Ethernet
Document code: MN67038_ENG Revision 2.003
Figure 8: "Update device" windows
Page 34 of 42