Update Via Serial - ADF Web HD67038-2-A1 User Manual

Industrial Electronic Devices

UPDATE VIA SERIAL:

By pressing the "Update Via
necessary. This by using the RS232 port.
Note:
With this type of update is possible to update only the hardware with jumpers (old version no longer sold).
In order to load the parameters or update the firmware in the device, follow these instructions:
Turn OFF the Device;
Connect the RS232 Null Modem cable form your PC to the Converter;
Put Dip2 of 'Dip-Switch A' in ON position;
Select the "COM port" and press the "Connect" button;
Turn ON the device;
Check the "Device state" Led. It must blink quickly (see "LEDS" section);
Press the "Next" button;
Select which operations you want to do.
Press the "Execute Update
When all the operations are "OK" turn OFF the device;
Put Dip2 of 'Dip-Switch A' in OFF position;
Turn ON the device.
At this point the configuration/firmware on the device is correctly updated.
Figure 7: "Update Device via
Serial" windows
ADFweb.com S.r.l.
Serial" button it is possible to load the created configuration into the device, and also the Firmware if is
Firmware" button to start the upload;
User Manual RS485 / RS232 / Ethernet
Document code: MN67038_ENG Revision 2.003 Page 33 of 42