Active Serial Driver - ADF Web HD67038-2-A1 User Manual

Industrial Electronic Devices

ACTIVE SERIAL DRIVER:

Before pressing the "Active Serial
Connector" software from the following link: www.adfweb.com/download/filefold/serial_ethernet_connector.zip.
After the installation of the software you have to enter in the SW67038, go into the "General Parameter" section and press the "ACTIVE
SERIAL DRIVER" button. At this point it is possible to configure the virtual COM port following these steps:
Go in the "Type" Section.
Step 1 – Active the Advanced
Mode;
Step 2 – Active the Client Mode;
Step 3 – Select the COM port to
use with the device. It is better if
you use a COM port that does not
exist in your system;
Step 4 – Insert the IP Address
and the Port of the Device and
then press the "ADD" button;
Step 5 – Check that the IP and
the Port are correct.
ADFweb.com S.r.l.
Driver" button from the "General Parameter" window it is necessary to download the "Serial to Ethernet
User Manual RS485 / RS232 / Ethernet
Document code: MN67038_ENG Revision 2.003 Page 37 of 42