Modifying The Co 2 Values - Sime UNIQA REVOLUTION Original Instructions Manual

– press the > button again to run the boiler at maximum power
again
– press the button y
Procedure". The boiler water delivery temperature will
appear on the display
– close the taps opened previously and check that the appliance
shuts down.
CO values
2
Type of gas
max
CO
2
min
7.9 Modifying the CO
Should the CO values read differ from those in the table, modify
2
as follows:
"PAR 73"
– keep the flue gas analyser inserted in the take-off point on
the outlet ducts
– go into the parameter section by pressing the buttons
t (for approximately 5 seconds) at the same time until "PAR
(parameter number) and the value set (0) appears on the
01"
display
– press and hold the t button and scroll through the parameters
until you reach "PAR 15"
– press and hold the < button to change the value to "0" (force
minimum power)
– the modified value will be stored automatically
– keep the button t pressed and scroll through the parameters
until reaching parameter "PAR 49"
to exit the "Chimney sweeper
G20 G30 G31
3,0 - 3,5 3,8 - 4,3 3,7 - 4,2
2,1 - 2,5 2,5 - 2,9 2,8 - 3,2
values
2
r
– press and hold the button
– the modified value will be stored automatically
– press and hold the
until you reach "PAR 73" (default value "20")
– increase or decrease "PAR 73" one unit at a time using the
or < buttons respectively, checking combustion
– the modified value will be stored automatically
and
– after the CO values have been modified, set "PAR 15" back to
2
– or the most suitable heating power – again
"100"
– exit the parameter section by pressing and holding down the
buttons r and t
until the delivery temperature is displayed.
> to set the value at "49"
t button and scroll through the parameters
(approximately 5 seconds)
at the same time
>
41