Display Of Operating Data And Counters - Sime UNIQA REVOLUTION Original Instructions Manual

7.5

Display of operating data and counters

Once the boiler is operating a qualified technician can view the
operating data and the counters as follows:
– from the operating screen in the mode enabled at that
moment (WINTER n
– go into "DISPLAY" by pressing the buttons
for more than 3 seconds until the following screen
same time
appears
From this point, the technician has 2 options:
– scroll through the list of "information (PAR)" and "counters
by pressing the button
(PARc)"
– display the "activated alarms" (no more than 10) by pressing
the button r
– Once in this section, proceed with button
When all the values have been displayed, exit the menu by
pressing and holding down the button
seconds until the initial screen is displayed.
36
or SUMMER )
l
r and
t . Scrolling will be in sequence
t or r .
y for approximately 5
TABLE OF INFORMATION DISPLAYED
Type No.
PAR 00
PAR 01
PAR 02
PAR 03
PAR 04
PAR 05
PAR 06
< at the
PAR 07
PAR 08
PAR 09
PAR 10
PAR 11
TABLE OF COUNTER DISPLAYED
Type No.
PAR c0
PAR c1
PAR c2
PAR c3
PAR c4
PAR c5
PAR c6
PAR c7
TABLE OF ACTIVATED ALARMS/FAULTS
Type No.
PAR A0
PAR A1
PAR A2
PAR A3
PAR A4
PAR A5
PAR A6
PAR A7
PAR A8
PAR A9
Description Range
SW version
- 9 ..
External sensor
99
Delivery sensor 1 - 9 ..
temperature 99
Delivery sensor 2 - 9 ..
temperature 99
Domestic hot water - 9 ..
sensor temperature 99
Air inlet probe (SIA) - 9 ..
display 99
Par.
Actual heating SET 13 ...
temperature Par.
14
0 ..
Power level
99
0 ..
Flow meter rate
99
Water pressure
transducer reading 0...99
(if resent)
Return probe 0 ..
display 99
Compressor (CP) ON/
status OFF
Description Range
total no. of boiler 0 ..
h x 1000
operating hours 99
total no. of burner 0 ..
h x 1000
operating hours 99
total no. of burner 0 ..
h x 1000
ignitions 99
0 ..
total no. faults
99
total no. of times
0 ..
PAR parameters
99
accessed
total no. of times
0 ..
OEM parameters
99
accessed
time unitl next
0 ..
maintenance months
99
intervention
total no. of 1 ..
calibrations 199
Description
Last activated alarm/fault
Last but one activated alarm/fault
Third from last activated alarm/fault
Previous activated alarm/fault
Previous activated alarm/fault
Previous activated alarm/fault
Previous activated alarm/fault
Previous activated alarm/fault
Previous activated alarm/fault
Previous activated alarm/fault
U/M Step
°C 1
°C 1
°C 1
°C 1
°C 1
°C 1
% 1
l/min 0.1
bar 0.1
°C 1
U/M Step
0.1; from
0.0 to 9.9;
1; from 10
to 99
0.1; from
0.0 to 9.9;
1; from 10
to 99
0.1; from
0.0 to 9.9;
1; from 10
to 99
x 1 1
x 1 1
x 1 1
1
x 1 1