Transport And Unpacking; System Setup - Advantech TPC-5212W-633AE User Manual

2.1

Transport and Unpacking

When accepting a delivery, please check the packaging for visible transport damage
and check the delivery for completeness by comparing it with your order form. If you
notice any shipping damage or inconsistencies between the contents and your order,
please inform the responsible delivery service immediately.
During transportation, the TPC system should be protected from excessive mechani-
cal stress. If the TPC system is transported or stored without packaging, shocks,
vibrations, pressure, and moisture may impact the unprotected unit. Additionally,
damaged packaging indicates that ambient conditions have already had a massive
impact on the device. Therefore, please use the original packaging during transporta-
tion and storage.
If the TPC system is transported in cold weather or is exposed to extreme variations
in temperature, ensure that moisture (condensation) does not build up on or inside
the HMI device. Moisture can result in short circuits and damage to the device. To
avoid damage, store the TPC system in a dry environment and bring the system to
room temperature before powering it up. If condensation occurs, a delay time of
approximately 12 hours must be allowed to ensure that the system is completely dry
before being switched on.
2.2

System Setup

1. Remove the SSD bay using the blue hand screws.
2. Place the SSD into the bay and affix it in place using the screws provided in the
accessory box.
TPC-5000 Series User Manual
Figure 2.1 Remove the SSD bay for SSD installation
Figure 2.2 Place the SSD into the bay
8