Panel Mounting - Advantech TPC-5212W-633AE User Manual

1.6

Panel Mounting

1. There is an adhesive waterproof gasket on the Mg front bezel. Ensure that the
waterproof gasket is in place before installing the TPC system in the panel
opening.
2. Install the TPC in the panel opening.
3. Retrieve the clamps and long screws from the accessory pack. Hook the clamps
the holes located on the four sides of the bezel. Insert screws into every clamp
and tighten them to fasten the clamp in place. These screws will push the
mounting panel and secure the unit.
4. The suggested mounting panel thickness is less than 6 mm (0.236 in).
Insert the screws into each clamp and tighten
them to fasten the clamp in place.
Hook the clamps into the holes and fasten the
screws
Torque: 2 kgf-cm
These screws will push the mounting panel and
secure the unit.
Figure 1.2 Panel mounting
5 TPC-5000 Series User Manual