Table of Contents
Advertisement
3.3.10
NVMe Configuration
The NVMe Configuration menu displays the NVMe controller and drive information
of the devices connected and allows you to configure NVMe device options
settings.
3.3.11
Power Management
Power Mode [ATX Type]
Select power supply mode. Configuration options: [ATX Type] [AT Type]
The following items appear when you set Power Mode to [ATX Type].
Restore AC Power Loss [Always Off]
[Last State]
The system goes into either off or on state, whatever the system
state was.
[Always On]
The system goes into on state after an AC power loss.
[Always Off]
The system goes into off state after an AC power loss.
RI Wake Event [Disabled]
Enable or disable system to wake up from RI#. Configuration options: [Enabled]
[Disabled]
RTC Wake system from S5 [Disabled]
[Disabled]
[Fixed Time]
[Dynamic Time]
3.3.12
Digital IO Port Configuration
The items listed in this screen configure Digital IO settings.
DIO Port1~DIO Port4 [Output]
Configuration options: [Input] [Output]
The following item appears only when you set DIO Port1/2/3/4 to [Output].
Output Level [High]
Configuration options: [High] [Low]
DIO Port5~DIO Port8 [Input]
Configuration options: [Input] [Output]
Chapter 3: BIOS setup
Disables system wake up from S5.
The system will wake up at the specified hr::min::sec.
The system will wake up at the current time plus a specified
3-11
Advertisement
Table of Contents
