Digital Io Port Configuration - Aaeon ATX-Q370A Manual

Restore AC Power Loss [Last State]
[Last State] The system goes into either off or on state, whatever the system
state was.
[Always On] The system goes into on state after an AC power loss.
[Always Off] The system goes into off state after an AC power loss.
RI Wake Event [Disabled]
Enable or disable system to wake up from RI#. Configuration options: [Enabled]
[Disabled]
RTC Wake system from S5 [Disabled]
[Disabled]
[Fixed Time]
[Dynamic Time]
The following items appear when Fixed Time is enabled.
Wake up day/hour/minute/second [0]
Specify the values for day/hour/minute/second.
The following item appears when Wake System with Dynamic Time is enabled.
Wake up minute increase [1]
Specify the number of minutes added to the current time before waking up
system. Input value range: [1~5]
3.3.10

Digital IO Port Configuration

The items listed in this screen configure Digital IO settings.
DIO Port1~DIO Port4 [Output]
Configuration options: [Input] [Output]
The following item appears only when you set DIO Port1/2/3/4 to [Output].
Output Level [High]
Configuration options: [High] [Low]
DIO Port5~DIO Port8 [Input]
Configuration options: [Input] [Output]
Chapter 3: BIOS setup
Disables system wake up from S5.
The system will wake up at the specified hr::min::sec.
The system will wake up at the current time plus a specified
number of minutes.
3-15