Adjustment Of Stabilizer; Adjustment Of Stabilizer; Dismounting The Implement; Dismounting The Implement - Kioti PX1002 Owner's Manual

caution
•
when you are attaching an
implement not requiring any
traction, mount the assem-
bling spot of the top link into
the hole "a".
•
when you are attaching an
implement. (like plow)
Requiring some traction, mount
the top link into the hole "b",
"c".
TG110-AU-06.indd 7
3-poInt HItcH ImpLement And LoAdeR opeRAtIon

adjustment of stabilizeR

(1) telescopic stabilizers (2) pin
1. Adjust the telescopic stabilizers
to control horizontal sway of the
implement. It is also used to set
the implement on the back of the
tractor in center.
2. to adjust the check link, pull out
the pin and adjust it until the de-
sired transverse moving distance
is obtained.

dismounting the implement

1. park the tractor with the implement
on the level ground and lower the
implement all the way down.
Install the implement support as
needed.
2. disconnect the top link and lower
links from the implement by re-
moving the pins.
3. be sure to insert the set pins, lynch
pins and snap pins back to the
TG1O610A
implement securely to keep those
safe.
4. stop the engine and move the re-
mote hydraulic control lever back
and forth to relief the hydraulic
pressure in the system before dis-
connecting hydraulic couplers.
5. put the top link back to its hook.
Hold both lower links together with
a rubber band. otherwise, the low-
er links can contact with rear tires
and cause damage to the lower
links and tires while driving.
6
- 
6
2013-01-22 오전 10:30:53