Applying Power To The Gateway Or Node - Banner SureCross DX80 Gateway Network Manual

SureCross Wireless I/O Network Manual
The LCD displays the text shown. While
Channel Search Mode runs, LED 1 is solid
red and LED 2 flashes yellow.
The device tests Network ID 2 for availability
and counts down from one minute, zero
seconds.
The selected Network ID is available for use.
LED 1 is solid red, LED 2 is solid yellow.

Applying Power to the Gateway or Node

2
3 1
5
4
* Do not apply more than 5.5V dc to the gray wire.
1. Apply power to the Gateway by connecting the 10 to 30V dc cable as shown.
The Gateway begins in RUN mode, displays the current network ID (NID), then identifies itself as a Gateway.
2. Apply power to the Node by connecting the 10 to 30V dc cable or the DX81 Battery Supply Module as shown. To apply power to a
FlexPower Node with an integrated battery, install the battery into the housing.
The Node starts in RUN mode, displays the current network ID, then identifies itself as a Node and lists its device ID.
rev. I
Single click
button 2
Select new NID
To ignore Channel
Search Mode results
Wire Color Gateway (10 to 30V
dc)
1 brown +10 to 30V dc input
2 white RS485 / D1 / B / +
3 blue dc common (GND)
4 black RS485 / D0 / A / -
5 gray Comms gnd
www.bannerengineering.com - tel: 763-544-3164
Apply power
to the Gateway
START
CHANNL
SEARCH
MODE
SEARCH
NID 2
1M 0S
Yes
Is the NID in
CUR 2
use?
NEW 2
No
Double click
NID OK
button 2
IGNORE RUN
Node (10 to 30V dc)
10 to 30V dc
dc common (GND)
To cancel Channel
Search Mode
Double click
button 2
ABORT
Node (FlexPower™)
dc common (GND)
3.6 to 5.5V dc*
57