Applying Power To The Gateway Or Node; Bind Radios To Form Networks - Banner Sure Cross Performance DX80 Instruction Manual

For more detailed instructions about setting up your wireless network, refer to the Quick Start Guide (p/n 128185). For
more information about using Performance and non-Performance radios within the same network, refer the technical note
titled Mixing Performance Radios and 150 mW Radios in the Same Network listed on the Wireless Support - FAQs section
of Banner's Wireless website.

3.3 Applying Power to the Gateway or Node

1
2
4
3
5
1. Apply power to the Gateway by connecting the 10 to 30 V dc cable as shown.
The Gateway begins in RUN mode, displays the current network ID (NID), then identifies itself as a Gateway.
2. Apply power to the Node by connecting the 10 to 30 V dc cable or the DX81 Battery Supply Module as shown. To apply
power to a FlexPower Node with an integrated battery, install the battery into the housing.
The Node starts in RUN mode, displays the current network ID, then identifies itself as a Node and lists its device ID.

3.4 Bind Radios to Form Networks

Binding Nodes to a Gateway ensures the Nodes only exchange data with the Gateway they are bound to. For a more
detailed definition of binding mode, refer to the Advanced Setup section of the SureCross Wireless I/O Networks
instruction manual.
Apply power to the Gateway and Nodes.
1. Enter binding mode on the Gateway.
• If you have a two-button Gateway, triple-click button 2
• If you have a one-button Gateway, triple-click the button
• If you have a Gateway with no buttons, remove the rotary dial access cover and set both the right and left rotary
dials to 0, then set both the right and left rotary dials to F.
Two-Button Gateway
The LEDs flash alternately when the Gateway is in binding mode. Any Node entering binding mode will bind to this
Gateway.
1 Do not apply more than 5.5 V dc to the gray wire.
All manuals and user guides at all-guides.com
Pin Wire Color Gateway (10 to 30 V
dc)
1 brown 10 to 30 V dc input
2 white RS485 / D1 / B / +
3 blue dc common (GND)
4 black RS485 / D0 / A / -
5 gray Comms gnd
www.bannerengineering.com - Tel: 763.544.3164
®
Sure Cross Performance DX80 Wireless I/O Networks
Node (10 to 30 V dc)
10 to 30 V dc
dc common (GND)
One-Button Gateway
Node (FlexPower)
dc common (GND)
3.6 to 5.5 V dc 1
15