Stopping Consistency Group - IBM Storwize V5010 Manual

6. Figure 10-146 shows the command-line output for the stop remote copy relationship.
Figure 10-146 Stop remote copy relationship command-line output
The new relationship status can be checked, as shown in Figure 10-147. The relationship
is now Consistent Stopped.
Figure 10-147 Checking remote copy synchronization status

10.10.13 Stopping Consistency Group

After it is started, the Consistency Group can be stopped, if necessary. You can also use this
task to enable write access to consistent secondary volumes.
Perform the following steps to stop a Consistency Group:
1. From the main navigation pane, select Copy Services → Remote Copy.
2. In the table, select the Consistency Group that you want to stop.
622
Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1