IBM Storwize V5010 Manual page 232

3. Confirm the automatic start of the iSCSI service (Figure 5-11).
Figure 5-11 Automatic start of the iSCSI service
4. The iSCSI Initiator Properties window opens. Select the Configuration tab (Figure 5-12).
Write down the initiator name of your Windows host because you use it later.
Figure 5-12 iSCSI Initiator Properties window
5. You can change the initiator name, or enable advanced authentication, but these actions
are out of the scope of our basic setup. By default, iSCSI authentication is not enabled.
More details are available at the IBM Knowledge Center for the Storwize V5000 at the
following address:
https://ibm.biz/BdjSrz
6. From the Configuration tab, you can change the initiator name, enable CHAP
authentication, and more. However, these tasks are beyond the scope of our basic setup.
210
Implementing the IBM Storwize V5000 Gen2 with IBM Spectrum Virtualize V8.1