NuWave Nutri-Pot 10Q Owner's Manual page 10

ADDITIONAL SAFEGUARDS (Continued)
9. Do not place the unit close to flammable materials and heating units or
wet environments.
10. Height of ingredients that is to be put into the Inner Pot should comply with
"Operating Instructions" section.
11. Do not break the Silicone Gasket. Do not replace it with other rubber
gaskets, nor use a tension belt to make it seal.
12. Check and clean the anti-clog filter and Pressure Release Valve regularly to
avoid being blocked.
13. Do not open the Lid when the Floater Valve is down.
14. Do not put anything on or use other objects to replace the Pressure
Release Valve.
15. Never use a towel to clog the gap between the Lid and the edge of
the Base.
16. The bottom of the Inner Pot and heating plate should be kept clean. Do not
put the Inner Pot on other heat sources. Do not replace the Inner Pot with
other containers.
17. Only use wood or plastic ladles, and spoons so as not to wear the non-stick
coating in the Inner Pot.
18. Do not attempt to move the unit while cooking. Only after the unit cools
down completely can it be moved. Move the unit using the Base's handles.
Do not try to hold and move from the Lid handle.
19. Do not disassemble on your own or try to replace with any parts that are not
manufactured by NuWave for the 10-Q Nutri-Pot
20. Make sure the steam pressure discharges completely before opening
the Lid.
21. Fit on the Water-Collection Box before use.
22. Contact our Customer Service Department at 1-877-689-2838 or via
email at help@nuwavenow.com for the following:
• If the main power cord is damaged.
• In case the unit emits a continuous amount of smoke while in use. It
is normal for some smoke to escape the appliance during the first
few uses.
10
Owner's Manual
.
®