NEC Express5800/R320f-E4 Installation Manual page 18

Express5800 series, vmware

Hide thumbs Also See for Express5800/R320f-E4:

Table of Contents

Chapter 1 Installing OS

Among the parameters, choose "Enabled" and press Enter.

The current display of the configuration for SAS Option ROM Scan will be changed to "Enabled".

10.

Select an item other than SAS Option ROM Scan, and press Enter. Select Disabled from the

parameters displayed, and press Enter. Repeat these steps for all items other than SAS Option ROM

Scan.

11.

Make sure that SAS Option ROM Scan shows Enabled, and all other items show Disabled.

This is the end of steps for enabling internal hard disk drive.

12.

Check the settings of XHCI Mode. Press [ESC] key two times to display the top of the Advanced

menu.

13.

Move the cursor onto "USB Configuration" and press Enter.

14.

Confirm that [XHCI Mode] is set to [Auto]. If not, set the value to [Auto].

15.

It continues to disable Legacy memory copy Function and OC boot monitoring Function.

Proceed to "Chapter 1 (1.5 Disabling Legacy memory copy Function)" to continue configuring.

Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)

1. Setup Procedure

Table of Contents