Checking Status Of Ft Server - NEC Express5800/R320f-E4 Installation Manual

Chapter 1 Installing OS
11. When the message below appears, enter "yes" to restart the system. The ESXi host restarts.
A host reboot is required to place these updates into service.
Enter 'yes' to reboot now or 'no' to allow a manual reboot later: [yes]
12. After making sure that the ESXi host is shutdown, take the ft control software Install DVD out from the
drive.

1.11.3 Checking status of ft server

1. After the ftSys Management Appliance restarts, check the duplication status. Confirm that the System
FT LED on the front of the server lights.
2. Run the following command to confirm if the system is running normally.
# /opt/ft/sbin/ft-verify
The results list for each of the configuration is output. If all items show [PASS], it indicates that the
installation has been completed successfully (Output example:).
ftSys Management Appliance hosted by xxx.xxx.xxx.xxx [PASS]
Host is configured with enough memory
ftSys installed on host
Host software version matches appliance (x.x.x-xxx)
ftSys Management Appliance firewall settings
Host Firmware Boot Type - requires Legacy BIOS
Host Legacy memory copy BIOS setting
ftSys Management Appliance installed on boot volume
Multiple paths to storage
Network Configuration
Host ftSys service started
Host logs available after reboot
DNS Configuration
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)
Note The message does not appear when ftSys Management Appliance is configured as the log
server.
Note Record the version (x.x.x-xxx) displayed in "Host software version matches appliance"
described above. This will be used in "2.2 Confirmation of the ft control software version".
1. Setup Procedure
System FT LED
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
[PASS]
63