NEC Express5800/R320f-E4 Installation Manual page 32

Chapter 1 Installing OS
Select "Exit Fast!UTIL", and then press Enter.
2-13
Select "Reboot System", and then press Enter to reboot the system.
2-14
3. Configure CPU/IO module 1.
Press the POWER switch on front panel to turn off the server.
Then, disconnect all the power cords from the server.
4. Connect power cords in the following order to start the system from CPU/IO module 1.
(1) Connect a power cord to AC inlet B.
(2) Connect a power cord to AC inlet A.
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)
32
Note Make sure that System POWER LED is unlit before disconnecting the power cord.

Note Wait at least 15 seconds after step (1), and then perform step (2).

If you disconnect a power cord, wait for at least 30 seconds before connecting it again.
Tips See Chapter 1 (1.2 Preparations for Setup) for AC inlet connector.
Important Make sure that the PRIMARY LED on CPU/IO module 1 is lit.
1. Setup Procedure