Connecting And Configuring Options - NEC Express5800/R320f-E4 Installation Manual

Chapter 1 Installing OS
1.12

Connecting and Configuring Options

If there is any optional PCI board or peripheral equipment to connect to NEC Express5800/ft series, turn off the
power to NEC Express5800/ft series, and connect it according to Chapter 2 (5.7 Installing, Removing and
Replacing PCI Card) in Maintenance Guide and the device's instruction.
For how to install and use hard disk drive, see Chapter 2 (2. Hard Disk Drive Operations) in Maintenance Guide.
Immediately after the installation completes, network configuration for a port is duplicated. When you change
the network configuration or configure the duplication setting by adding a LAN card, it is necessary to configure
the settings from Host Client.
For detailed procedures, refer to the User's Guide packaged with this guide and VMware vSphere documents
from the following Website.
https://docs.vmware.com/en/VMware-vSphere/index.html
* The contents of this web site is subject to change or delete without notice.
For how to add LAN cards or configure the duplicated network, see Chapter 2 (3. Duplex LAN Configuration and
or 5.7 Installing, Removing and Replacing PCI Card) in Maintenance Guide.
To have enough time to initialize Fibre Channel disk and Fibre Channel switch and so on, adjust [Server] -
[Power On Delay Time] by setting System BIOS configuration Utility.
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)
64
1. Setup Procedure