Enabling Fibre Channel Card - NEC Express5800/R320f-E4 Installation Manual

Chapter 1 Installing OS
1.4

Enabling Fibre Channel card

The following procedure shows when installing or reinstalling VMware ESXi to the external storage.
1. Turn on the display and the peripheral equipment connected to the server.
2. Remove the front bezel.
3. Press the POWER switch that is located on the front side of the server.
Lift the acrylic cover, and press the POWER switch.
Important
After a while, the "NEC" logo will appear on the screen.
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Installation Guide (VMware)
Note If the power cords are connected to a power controller like a UPS, make sure that it is
powered on.
Note Make sure that Module POWER LEDs on both CPU/IO modules 0 and 1 are blinking, then
press the POWER switch.
Do not turn off the power before the "NEC"
logo appears.
Tips While the "NEC" logo is displayed on the screen, the server performs a power-on self test
(POST) to check itself. For details, refer to Chapter 3 (1.1 POST) in User's Guide.
Note If the server detects errors during POST, it will interrupt POST and display the error
message. Refer to Chapter 1 (6.2 POST Error Message) in Maintenance Guide.
Acrylic cover
POWER switch
1. Setup Procedure
19