Bc10 Display Settings; Bc10 Display Codes - Worcester GB162-65 Installation And Servicing Instruction

14.3 BC10 DISPLAY SETTINGS

Display
setting Meaning of display setting
[l/9/9|
Configured target load (65 kW).
[l/9/9|
Configured target load (80 kW).
[l/9/9|
Configured target load (100 kW).
[f/\.5|
Configured target value of the
pump run-over time.
Note: Do not set a pump
run-over time of less than
[f/\/5| (= 5 minutes).
[c/\.1|
DHW supply operating condition
setting.
Please note: If the setting [c/\/0| is
displayed, the frost protection of
the DHW supply has also been
switched off.
Table 23 Display settings

14.4 BC10 DISPLAY CODES

Main Sub
display display
z z
code code
[\/-/\|
[\/-/\|
[-/a/\] [2/0/8|
e e
1) 2)
e [-/h/\| e [2/0/0|
2)
Table 24 Display codes
6 720 648 726 (2011/07)
Display settings
Unit
%
%
%
min.
not
appli-
cable
Display codes
Display code
Key to display code
z
Operating phase:
Communication test while starting up. This
display code flashes 5 times within
5 seconds while starting up to indicate that
the communication between the UBA 3 and
the BC10 basic controller is being tested. If
a new UBA 3 or a new KIM was fitted, this
code will flash for max. 10 seconds.
Fault:
If this code continues to flash on the display,
there is a fault in the communication
between the UBA 3 and the BC10 basic
controller.
Operating phase:
The boiler is in flue gas test or service mode.
Operating phase:
The boiler is in heating mode.
Range
[l/2/0| [l/9/9|
–
[l/2/5| [l/9/9|
–
[l/2/0| [l/9/9|
–
[f/0/0| [f/6/0|
–
[c/\/0|
Off
Reset
requi-
red?
DISPLAY INFORMATION
Factory
adjusted
setting
[l/-/-| [l/-/-|
/ 100 %
[l/-/-| [l/-/-|
/ 100 %
[l/-/-| [l/-/-|
/ 100 %
[f/1/d| [f/\/5|
/ 24 h
[c/\/1|
/ On
LED on Other effects
UBA 3
Off or
flashing
at 8 Hz
Off or
flashing
at 8 Hz
Off or No heating operation
flashing and no DHW.
at 8 Hz
Off
71