Inspection Log Book; Measuring The Carbon Monoxide Content (Co), Air Free - Worcester GB162-65 Installation And Servicing Instruction

12.12 INSPECTION LOG BOOK

B Enter your signature and the date after completing the inspection activities.
Inspection activities
1. Checking the general condition of
the heating system.
2. Carrying out a visual inspection and
function test of the heating system.
3. Checking the gas and water-bearing
system components for:
• Operational tightness
• Visible corrosion
• Signs of wear.
4. Measuring the ionisation current.
5. Measuring the gas supply pressure
(working pressure).
6. Checking the gas/air-ratio.
7. Carrying out a tightness check of the
gas circuit in operating conditions.
8. Measuring the carbon monoxide
content (CO), air free.
9. Checking the system pressure.
• Pre-pressure of expansion vessel
(also see installation instructions
for expansion vessel)
• Filling pressure.
10. Checking the operation and safety of
the air intake and flue gas pipe.
11. Checking the boiler settings of the
control device (in accordance with
requirements).
12. Final check of the inspection
activities, documenting the
measurement and test results.
13. Confirming proper inspection.
Table 20
6 720 648 726 (2011/07)
Date: ________
Section 10.2.8,
page 54.
Section 12.3,
page 61.
Section 10.2.11, ___________ μA
page 55.
Section 10.2.6, ________ mbar
page 51.
Section 10.2.7, _________ Pa
page 51.
Section 10.2.8,
page 54.
Section 10.2.9, _________ ppm
page 55.
Section 10.1,
page 47.
_________ bar
_________ bar
Section 10.2.4,
page 51.
See the
documents for
the control
device.
Company
stamp/
signature/
date
INSPECTION
Date: ________ Date: ________
___________ μA ___________ μA
________ mbar ________ mbar
_________ Pa _________ Pa
_________ ppm _________ ppm
_________ bar _________ bar
_________ bar _________ bar
Company Company
stamp/ stamp/
signature/ signature/
date date
63