Keysight Technologies PXA N9030A Getting Started Manual page 23

Quick Start
Instrument Information
Cleaning Connectors
Cleaning connectors with alcohol shall only be done with the instrument power
cord removed, and in a well-ventilated area. Allow all residual alcohol moisture
to evaporate, and the fumes to dissipate prior to energizing the instrument.
Keep isopropyl alcohol away from heat, sparks, and flame. Store in a
WARNING
tightly closed container. It is extremely flammable. In case of fire, use
alcohol foam, dry chemical, or carbon dioxide; water may be
ineffective.
Use isopropyl alcohol with adequate ventilation and avoid contact with
eyes, skin, and clothing. It causes skin irritation, may cause eye
damage, and is harmful if swallowed or inhaled. It may be harmful if
absorbed through the skin. Wash thoroughly after handling.
In case of spill, soak up with sand or earth. Flush spill area with water.
Dispose of isopropyl alcohol in accordance with all applicable federal,
state, and local environmental regulations.
Battery Information
The analyzer uses a lithium battery located on the CPU board. This is not an
operator replaceable part. See
page
Technologies.
Service documentation is available at www.keysight.com.
Danger of explosion if battery is incorrectly replaced. Replace only with
WARNING
the same or equivalent type recommended. Discard used batteries
according to the manufacturer's instructions.
Do not throw batteries away but collect as small chemical waste.
113. Replaceable parts must be approved or supplied by Keysight
"Returning an Analyzer for Service" on
23