Vidyo VidyoPanorama Installation And Configuration Manual page 27

e.
Connect the RJ-45 connector on an RJ-45 cable to the Link Out port on the third Interact mi-
crophone, and connect the RJ-45 connector on the other end of the cable to the Link In port
on the Interact AT audio mixer.
f.
Connect the speaker wire from the Interact AT audio mixer to both of the speakers.
g.
If you are using ClearOne speakers, ensure that the wattage on the speakers is set to 8
Ohms.
Note: Vidyo tested this ClearOne audio option with ClearOne firmware version 1.0.27.0 and
1.0.40.0.

If you have the USB I/O option:
a.
Connect a USB connector on a USB cable to a USB connector on the Controller Node, and
connect the USB connector on the other end of the cable to the USB audio interface.
b.
Connect an XLR connector on an XLR cable to the Audio Left Out port on the USB audio in-
terface, and connect the XLR connector on the other end of the cable to the Audio Input port
on audio amplifier/mixer.
c.
Connect an XLR connector on an XLR cable to the Audio Right Out port on the USB audio in-
terface, and connect the XLR connector on the other end of the cable to the Audio Input port
on the audio amplifier/mixer.
d.
Connect the XLR connector on an XLR-to-Mic cable to the Left Input port on the USB audio
interface, and connect the Mic connector on the other end of the cable to the XLR micro-
phone.
e.
Connect the XLR connector on an XLR-to-Mic cable to the Right Input port on the USB audio
interface, and connect the Mic connector on the other end of the cable to the XLR micro-
phone.
f.
Connect the speaker wire from the audio amplifier/mixer to both of the speakers.
4. Connect the Ethernet cables:
a.
Connect an Ethernet cable from the Controller Node to the network switch.
27
Chapter 2: Installing VidyoPanorama