Vidyo VidyoPanorama Installation And Configuration Manual page 24

g.
Connect a VGA male connector on a VGA-to-VGA cable to the VGA port on the VGA2USB LR frame
grabber, and run the other end of the cable (also male) to the table so conference participants
can use it to connect to their PCs for content sharing.
h.
If you have a small VGA monitor that you want to use with the Controller Node, connect a VGA
connector on a VGA-to-VGA cable to the Console port on the KVM, and connect the VGA con-
nector on the other end of the cable to the small VGA monitor.
i.
If you have a keyboard and mouse that you want to use with the Controller Node, connect a USB
connector on a USB-to-USB cable to a USB port on the Controller Node, and connect the USB
connector on the other end of the cable to the keyboard.
2. Connect the camera cables:
a.
Connect the 9-pin female serial connector on the VISCA cable to the 9-pin serial port on the
Controller Node, and connect the male end of the VISCA cable to the VISCA In port at the back of
the camera.
b.
Connect one DVI connector on a DVI-to-DVI cable to the DVI Video Out port on the camera, and
connect the DVI connector on the other end of the cable to the DVI Video In port on the Control-
ler Node.
c.
If you are using the Vidyo-supplied camera, ensure that the System Select arrow on the back of
the camera is set to 0 (zero).
24
Chapter 2: Installing VidyoPanorama