Table of Contents
Advertisement
This chapter describes how to install VidyoPanorama. It includes information about how to:
Install the hardware
Access the interface for each Decoder Node
Enabling access to the VidyoRemote
To ensure the highest quality audio and video for your VidyoPanorama system, Vidyo recommends working
with an AV engineer or integrator during the installation process.
INSTALLING THE HARDWARE
Before you begin the installation process, you must ensure that rack rails supplied with VidyoPanorama will
work with the equipment rack you purchased. Once you have checked the rack mounting, you can install
and cable the Controller Node, Decoder Nodes, and the remaining system components.
Checking the Rack Mounting
Rack-mount rails are provided with VidyoPanorama to enable you to install the Controller Node and Decoder
Nodes into your equipment rack. You must ensure that these rails will work with the rack you purchased.
The provided static rack rails support tool-less mounting in 19"-wide, EIA-310-E compliant square hole and
unthreaded round hole racks. The rails also support tooled mounting for four-post threaded and two-post
(Telco) racks. You must provide your own screws when mounting the rails in threaded or two-post racks.
The adjustment range of the rails depends on the type of rack in which they are mounted. The values listed
below represent the allowable distance between the front and rear mounting flanges in the rack.
Mounting Hole Type
Square
Round
Threaded
Installing VidyoPanorama
Rack Adjustability Range
Minimum: 608 mm
Maximum: 879 mm
Minimum: 594 mm
Maximum: 872 mm
Minimum: 604 mm
Maximum: 890 mm
21
Chapter 2: Installing VidyoPanorama
2
Rail Depth (without CMA)
622 mm
Advertisement
Table of Contents
