Vidyo VidyoPanorama Installation And Configuration Manual page 26

f.
Connect the XLR connector on the XLR-to-Mic cable to the Mic 3 port on the Interact Mic EX,
and connect the Mic connector on the other end of the cable to the XLR microphone.
g.
Connect the speaker wire from the Interact AT audio mixer to both of the speakers.
h.
If you are using ClearOne speakers, ensure that the wattage on the speakers is set to 8
Ohms.
Note: Vidyo tested this ClearOne audio option with ClearOne firmware version 1.0.27.0 and
1.0.40.0.

If you have the ClearOne Interact AT option with the Interact ClearOne microphones:
a.
Connect a USB connector on a USB cable to a USB connector on the Controller Node, and
connect the USB connector on the other end of the cable to the Interact Com-W.
b.
Connect the RJ-45 connector on an RJ-45 cable to the Link Out port on the Interact Com-W,
and connect the RJ-45 connector on the other end of the cable to the Link In port on the first
ClearOne Interact microphone.
c.
Connect the RJ-45 connector on an RJ-45 cable to the Link Out port on the first Interact mi-
crophone, and connect the RJ-45 connector on the other end of the cable to the Link In port
on the second Interact microphone.
d.
Connect the RJ-45 connector on an RJ-45 cable to the Link Out port on the second Interact
microphone, and connect the RJ-45 connector on the other end of the cable to the Link In
port on the third Interact microphone.
26
Chapter 2: Installing VidyoPanorama