Checking The Equipment - Vidyo VidyoPanorama Installation And Configuration Manual

CHECKING THE EQUIPMENT

Once you have selected and prepared the room in which you are going to install the VidyoPanorama system,
you can begin unpacking the equipment. When unpacking, check that you have received all of these
components in your VidyoPanorama kit:
Item
Controller Node
(also known as the Control Point)
Three to Nine Decoder Nodes
Rack-Mount Rails
Cables
VidyoRemote™ and Docking
Station
Camera
Epiphan USB2VGA LR adapter
In addition to the equipment shipped in your VidyoPanorama kit, you'll also need the following equipment.
The ClearOne audio options can be purchased from Vidyo; all of the other equipment listed below can be
purchased from third-party suppliers based on Vidyo's recommendations:

Three to nine widescreen displays (one for each Decoder Node)

Equipment rack
 Network switch and cables

Wireless access point

Power distribution unit or uninterruptible power supply
 Additional audio and video cables

KVM switch (optional)
Additional Information
Server that runs VidyoPanorama controller node and
encoder software
Servers that run VidyoPanorama Decoder Node software

One set for each Decoder Node
 One set for the Controller Node

HDMI-to-DVI cables, 15 ft (4.57 m), one per Decoder Node
and one for the Controller Node

HDMI-to-DVI adapters, one per HDMI-to-DVI cable

Ethernet cables, 7 ft (2.133 m), one per Decoder Node
and one for the Controller Node; all connect to the Net-
work switch

VISCA camera control serial cable, 15 ft (4.57 m)
 DVI-to-DVI camera cable

Power cables for the Controller Node and each Decoder
Node

Speaker wires
VidyoPanorama's touch-screen remote control
Sony EVI-HD7 1080p/60 camera
Used for content sharing
19
Chapter 1: Preparing for the Installation