TP-Link TL-WR902AC User Manual page 72

Chapter 4
The values you configure for the Egress Bandwidth and Ingress Bandwidth should be
less than 100,000Kbps. For optimal control of the bandwidth, please select the right
Line Type and consult your ISP for the total egress and ingress bandwidth.
• Enable Bandwidth Control
can take effect.
• Egress Bandwidth
• Ingress Bandwidth
• Description - This is the information about the rules such as address range.
• Priority - Priority of Bandwidth Control rules. '1' stands for the highest priority while
'8' stands for the lowest priority. The total Upstream/ Downstream Bandwidth is first
allocated to guarantee all the Min Rate of Bandwidth Control rules. If there is any
bandwidth left, it is first allocated to the rule with the highest priority, then to the rule
with the second highest priority, and so on.
• Egress Bandwidth
WAN port. The default is 0.
• Ingress Bandwidth
the WAN port. The default is 0.
• Status - Rule status, show whether the rule takes effect.
• Edit - Choose to edit or delete an existing entry.
¾ To add a Bandwidth control rule:
1. Click Add New.
2. Enter the information as the figure shown below.
- Check this box so that the Bandwidth Control settings
- The upload speed through the WAN port.
- The download speed through the WAN port.
- This field displays the max and min upload bandwidth through the
- This field displays the max and min download bandwidth through
Configure the Router in Wireless Router Mode
65