Page 1
Wireless Bridge Quick Start Guide This device is for the purpose of connecting a FlexRadio to a wireless network when it is not possible to connect the radio directly to the router with a physical cable. Package Includes: WR-902AC Wi-F Travel Router RJ45 Ethernet Cable Power Adapter Quick Start Guide...
Setup Instructions 1. Set hub to “AP/Rng Ext/Client” setting on the side of the device 2. Plug in the device using supplied AC plug and USB adapter cord 3. On your smart phone select the wifi device “TP-Link_XXXX”. The XXXX will be a series of unique letters and numbers.
Page 3
4. Enter the wifi password listed under the 2 nd barcode on the back of your device. The number in the picture below is just a sample. Your number will be different. a. This is a temporary connection, so you do not want to remember this access point name and password if you are asked.
Page 4
9. On the following screen locate the wifi router id you will be using by hitting SCAN. (This is NOT the tp-link router, this is your personal WiFi network) and click the “Connect” link at the far right of the table. This will prompt you to enter your wifi password. You may see many WiFI access points, so make sure you pick the same WiFi access point you use for your home.
Page 5
TP Link Hub . Also, make sure that you do provide power to the TP-LINK adapter in case you needed to move the TP-Link bridge to a new location. Use the supplied cables and power adapter.
Page 6
‘TP-Link Bridge’ did not correctly connect to your WiFi. The quickest resolution is to Reset the TP-Link Bridge by pushing in the Reset button for 5 seconds with the power applied to the TP-Link Bridge. Once TP-Link Bridge has restarted, start at the above from Step 1 and double check all your steps.