Usb Settings; Storage Sharing - TP-Link TL-WR902AC User Manual

Chapter 6
• Client Name - The name of the DHCP client.
• MAC Address - The MAC address of the DHCP client.
• Assigned IP - The IP address that the router has allocated to the DHCP client.
• Lease Time - The time of the DHCP client leased. After the dynamic IP address has
expired, a new dynamic IP address will be automatically assigned to the user.
You cannot change any of the values on this page. To update this page and show the
current attached devices, click Refresh.
6. 6.

USB Settings

You can insert a USB drive to share files among users on the LAN, access the USB drive
remotely on the internet and enjoy videos and photos stored in the USB drive.
6. 6. 1.

Storage Sharing

Share your USB storage device with different users on the network.
¾ To access the USB disk:
1. Connect Your USB Disk
Insert your USB storage device into the router's USB port directly or using a USB cable.
Wait several seconds until the USB LED becomes solid on.
Tips:
• If you use USB hubs, make sure no more than 2 devices are connected to the router.
• If the USB storage device requires using bundled external power, make sure the external power has been
connected.
• If you use a USB hard drive, make sure its file system is FAT32 or NTFS.
• Before you physically disconnect a USB device from the router, safely remove it to avoid data damage:
Go to USB Settings > USB Mass Storage
2. Access Your USB Disk
By default, all the network clients can access your USB disk. Refer to the following table
for access instructions. You can customize user accounts by referring to
Configure the Router in Range Extender Mode
and click Disconnect.
User Accounts.
117