TP-Link TL-WR902AC User Manual page 41

Chapter 4
• Disable Wireless Security
If disabled, wireless clients can connect to the router without a password. It's strongly
recommended to choose one of the following modes to enable security.
• WPA/WPA2-Personal
passphrase.
• Version - Select Auto,
• Encryption - Select Auto,
• Wireless Password
the length should be between 8 and 64 characters; for ASCII, the length should
be between 8 and 63 characters.
• Group Key Update Period
The value can be 0 or at least 30. Enter 0 to disable the update.
• WPA/WPA2-Enterprise
• Version - Select Auto,
• Encryption - Select Auto,
• Radius Server IP
• Radius Port
• Radius Password
• Group Key Update Period
The value should be 30 or above. Enter 0 to disable the update.
• WEP - It is based on the IEEE 802.11 standard.
- The wireless security function can be enabled or disabled.
- It's the WPA/WPA2 authentication type based on pre-shared
WPA-PSK
TKIP or AES.
- Enter ASCII or Hexadecimal characters. For Hexadecimal,
- Specify the group key update interval in seconds.
- It's based on Radius Server.
WPA or WPA2.
TKIP or AES.
- Enter the IP address of the Radius server.
- Enter the port that Radius server used.
- Enter the password for the Radius server.
- Specify the group key update interval in seconds.
Configure the Router in Wireless Router Mode
or WPA2-PSK.
34