TS-300 Profile Engine
Backside
Fig. 03
12) Neutrik 3-pin DMX signal connector IN
13) Neutrik 5-pin DMX signal connector IN
14) Neutrik 3-pin DMX signal connector OUT
15) Neutrik 5-pin DMX signal connector OUT
16) Neutrik PowerCON IN (Blue)
17) Neutrik PowerCON OUT (Grey)
Installation
Remove all packing materials from the Infinity TS-300 Profile Engine. Check that all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Ordercode: 200001
11