Backside; Installation; Set Up And Operation - Infinity TF-260C7 Fresnel Manual

TF-260C7 Fresnel

Backside

Fig. 03
08) Neutrik 3-pin DMX signal connector IN
09) Neutrik 5-pin DMX signal connector IN
10) Neutrik 3-pin DMX signal connector OUT
11) Neutrik 5-pin DMX signal connector OUT
12) Neutrik PowerCON IN (Blue)
13) Neutrik PowerCON OUT (Grey)
14) Manual Focus

Installation

Remove all packing materials from the Infinity TF-260C7 Fresnel. Check that all foam and plastic padding
is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Ordercode: 200203
10