Overview; Backside; Installation; Set Up And Operation - Infinity iB-2R Manual

Infinity iB-2R

Overview

01) Lens
02) LCD display
03) 5-pin DMX signal connector IN
04) 5-pin DMX signal connector OUT
05) 3-pin DMX signal connector IN
NOTE: Knowledge of DMX is required to fully utilize this unit.

Installation

Remove all packing materials from the Infinity iB-2R. Check that all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.

Control Modes

There are 2 modes:

One Infinity (Built-in Programs)

01) Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Infinity is not connected by a DMX-cable, it functions as a stand-alone device.
05) Please see page 16 for more information about the built-in programs.
Ordercode: 41531
Fig. 01
● Stand-alone (built-in programs)
● DMX512 (15CH, 19CH)

Backside

06) 3-pin DMX signal connector OUT
07) Neutrik Powercon IN
08) Fuse 5A/250V
09) Power switch ON/OFF
10) Ground/Earth connection
8
Fig. 02