How To Assemble Aps (Automatic Pumping System) - Rcom PRO PLUS 10 User Manual

North America Sales & Service www.RcomCo.com
▶ Please insert air filer into the lower groove of egg turning disk as shown in the picture
3day before hatching.
Please wash the air filter before use, as dust in the air filter during use this may disrupt
proper air circulation.
▶ Assemble in this order : view-window, egg rotation disk,
main controller and fix the view window and main controller
with 3 hooks.
(In the PRO 10 model the nipple and APS are sold
separately.)
When assembled,the grooves of air control lever and view-
window should line up.
▶ It is recommended to sterilize both the eggs and the incubator interior before loading the
eggs. [Reference Rcom Antiseptic Solution] Assemble the main body (lower part) and tray
and place the eggs in, adjusting the location according to egg size.
It is recommended to locate the sharper point of the egg to the inner side of the device.
▶ Place the eggs and close the view-window.
If the view-window is not completely closed the temperature will not increase.
Turn the device on before placing the eggs thus verifying all the functions are performing
normally, then start the incubation once verified.
▶ Insert the power cord and pump power* jack to the upper side of the product.
(*Pump pack and/or Rcom PRO PLUS 10 model sold seperately.)
Please pay special attention and do not to switch the location of power cord and pump
power jack.
[In case of PRO PLUS 10 model]
▶ Connect the OUT side silicone tube of the automatic pumping system (APS) to the nipple
of
the device, and put the silicone tube of IN side to the PET water bottle.
In case of PRO PLUS 10 model do not pour water to the water hole in the lower part
of the main body as it includes automatic pumping system (APS).
If the silicone tube is not exactly inserted the pumping may not work properly.
Never shake or reverse the main body of the device after filling the water.
Any spilled or leaked water may cause device breakdown.
[In case of PRO 10 model]
▶ Pour the water into the water hole of the lower part of the main body. The silicone hose
will
supply water to the interior of the incubator. Pay special attention to prevent overflow.
During incubation please verify daily if there is water in the water hole and when
insufficient
please supply water.
(Reference 3. Incubation/Function setup → (1) Function
In the PRO 10 model, the APS is sold seperately. It can be purchased and installed as
the PRO PLUS 10 model. When the APS is installed, do not pour water to the water
hole in the lower part of the main body.
2. BEFORE USE

How to assemble APS (Automatic Pumping System)

[Image 1-0]
Rcom Bird Egg Incubator Eco Pro Plus 10 User Manual
setup)
*Unnecessary in initial purchase
(3) APS (How to assemble / control speed / replace tube / store and clean)
[Image 1-1] [Image 1-2] [Image 1-3]
Automatic Pumping System