How To Do Factory Initialization; Blackout Notification Function; Pro Plus 10 : How To Forcibly Operate Humidifying Pump; Candling Function - Rcom PRO PLUS 10 User Manual

North America Sales & Service www.RcomCo.com
▶ By pressing the + and OK buttons for 3 seconds at the same time the OPTN(option) sign
appears.
▶ Press + or - button, select 0.ESC and press OK and you can exit from the optional function
setup.

How to do Factory Initialization

▶ When the input values are incorrect, use factory default function to initialize the device to
the initial status launched from the factory.
▶ When inserted the power by pressing the OK button at the same time, the RST sign is

Blackout Notification Function

▶ During the incubation the
10 seconds.
When pressed OK button it is suspended and the power sign is immediately disappears.

PRO PLUS 10 : How to forcibly operate humidifying pump

▶ The pump motor may be tested by pressing the + button for 5 seconds during operation.
▶ The pump motor may be tested for 2 mins by pressing the + button for 10 seconds during operation. In this moment the pump motor works even the
button is not pressed directly.
If you press any button during the consecutive 2 minutes operation, the pump operation is immediately suspended.

Candling function

Candling allows observation of the fertilized, unfertilized, suspended hatching or development of embryo, and if there is any minute fissure on the egg
introducing to the incubator the germs penetrate into it therefore the decomposition starts. As the decomposed egg may contaminate other eggs,
it is recommendable to perform candling in dark environment to select the proper ones.
Do not directly look into the LED light except in case of candling (egg examination).
▶ The environment for candling must be dark for easier observation.
▶ Pull up carefully the main controller and the handle of main body (upper part) and take the
egg to examine/candle.
▶ Place the wide, round part of the egg onto the candling zone of the main body (upper
part), press the Candling button and observe the interior of the egg (embryo or blood vessel).
The candling can be verified by naked eye from 5~7 days after initiation of incubation,
and if the blood vessel or embryo (chick) is not observed the egg may be unfertilized
therefore remove it from the incubator.
If the egg shell is thick or dark it may be difficult to verify with naked eye.
White eggs as duck eggs are easier to observe.
It is not recommended to candle over 10 minutes within a warm indoor environment.
Please pay special attention not to apply any impact on the egg.
The egg may die due to stress caused by severe shaking or turning.
Too frequent candling may cause failure to hatch.
3. INCUBATION / FUNCTION SETUP
Humidity and ventilation control during incubation
▶ Humidity must be maintained before hatching to prevent drying of egg shell or non hatch.
▶ It is not recommended to open the cover frequently in the hatching period.
If the cover is frequently opened the humidity is rapidly reduced and it may take long time
to recover the humidity again.
※ If the internal temperature of the device is 37℃ (98.6℉) or over, and the temperature of
hatching room is lower then humidity may not reach RH 65%. There might be ±5% of
tolerance in humidity and there is no significant problem for hatching.
Rcom Bird Egg Incubator Eco Pro Plus 10 User Manual
power sign in display flickers and sounds the alarm for
(3) Moist and ventilation during incubation /
(4) Management after incubation / Dew condensation
after