Selecting Video Memory; Selecting An Aspect Ratio; Adjusting The Picture - Runco Reflection Owner's Operating Manual

Basic Operation

Selecting Video Memory

Selecting an Aspect Ratio

Adjusting the Picture

ISF ISF
MEM1 FACT
NIGHT DAY
ANA
4X3 LBOX VWIDE
16X9
1 2
CINEMA VCINE
BRT CONT COL TNT
28
• Press MEM1 to recall custom memory
settings.
• Press ISF NIGHT to recall ISF Night
settings.
• Press ISF DAY to recall ISF Day
settings.
NOTE: ISF settings must be calibrated
and stored by a certified ISF calibrator.
For more information, please go to
www.imagingscience.com.
Press FACT (Factory) to restore factory
•
settings for the current source. An on-
screen confirmation message appears.
Press FACT again to confirm.
Select an aspect ratio that suits the format of
the video signal. The following aspect ratios
are available.
• CINEMA: The image in the Letterbox mode
is enlarged to a 16x9 image and the upper
and lower portions are compressed.
• ANA16X9 (Anamorphic): A 4:3 image is
stretched horizontally to fit a 16:9 screen.
This setting is for 16:9 DVDs and HDTV
programs.
• 4 X 3 (Standard 4:3): The input signal is
scaled to fit a 4:3 display mode in the center
of the screen.
• LBOX (Letterbox): An image in letterbox
format is enlarged to fit a 16:9 full screen
display; the upper and lower portions are
compressed.
VWIDE (Virtual Wide): This setting
•
transforms a 4x3 image to a 16x9 image.
• VCINE (Virtual Cinema): A 2.35 image is
stretched vertically in both directions to fill
a 16:9 image.
• Press BRT (Brightness) to adjust picture
brightness.
• Press CONT (Contrast) to adjust picture
contrast.
Press COL (Color) to adjust color
•
intensity.
• Press TNT (Tint) to adjust color tones.
Runco CL-610 Owner's Operating Manual