Troubleshooting - Runco Reflection Owner's Operating Manual

PROBLEM
The projector There is no power from the
does not turn on power cable.
The power switch is not turned
on.
The projector was turned on
again within the cool down
time.
Lamp cover is not attached
well.
No picture
The lamp cover is not correctly
attached.
The projector is not correctly
connected to the input source
device.
The input signal has not been
correctly selected.
TEMP LED or LAMP LED
blinking.
Image is unstable The connection cables are not
connected to the projector.
Picture is blurred The projection lens is not
correctly focused.
The projector and the screen
are not aligned squarely.
Remote control The batteries are exhausted.
does not work
correctly
LAMP LED blinks The cooling fan does not work
red well.
The temperature inside the
projector is extremely high.
LAMP LED blinks
The lamp has exceed its
red; POWER LED specified usage hours.
is green
The lamp has burned out.
Runco CL-610 Owner's Operating Manual
POSSIBLE CAUSE REMEDY
Plug the power cord into the
AC power socket on the rear of
the projector and an electrical
outlet.
Turn on the power switch.
Wait until projector completes
the cool down time.
Correctly attach the lamp cover.
Correctly attach the lamp cover.
Check the connection.
Select the correct input signal
with the SOURCE input keys:
VID, S-VID, COMP1, COMP2,
RGBHD or HDMI.
Please contact your Runco
dealer for assistance.
Correctly connect the cables to
the appropriate terminals.
Adjust the focus of the
projection lens with the focus
ring.
Adjust the projection angle and
direction, and the height of the
projector.
Replace both batteries with
new ones.
Please contact your Runco
dealer for assistance.
Check that the ventilation holes
are not blocked.
Replace the lamp with a new
one.
Replace the lamp with a new
one.
47

Troubleshooting