Operation; Selecting Video Memory; Selecting An Aspect Ratio; Selecting An Input Source - Runco LightStyle LS-1 series Operation Manual

Press M1, M2 or M3 to recall settings from a memory preset. Then, press ENTER to
confirm your selection. Or, to cancel the operation, press
ENTER.
You can assign each of these three buttons to any of four
memory presets. For more information, refer to M1 Key /
M2 Key / M3 Key on page 67.
Press the aspect ratio (
program material being viewed.
When you turn on the LS-1, it switches to the last
selected input and looks for a valid signal.
Use these buttons on the remote control to select an
input source directly. You can assign each of these five
buttons to any input. The default assignments are:
1 = HDMI 1, 2 = HDMI 2, 3 = Component, 4 = S-Video,
5 = Video.
For more information, refer to 1 Key / 2 Key / 3 Key / 4 Key / 5 Key on page 67.
Runco LS-1 Installation/Operation Manual
) button to select the appropriate aspect ratio for the type of
to select Cancel and press
USER MEMORY
M1 M2 M3
SHARP
SOURCE
1 2 3
4 5
▲
45

4. Operation

4.1
Selecting Video
Memory
4.2
Selecting an Aspect
Ratio
4.3
Selecting An Input
Source
Operation