Isf Calibration - Runco Reflection Owner's Operating Manual

The CL-610 has been designed to incorporate setup and calibration standards
established by the Imaging Science Foundation (ISF). The ISF has developed carefully
crafted, industry-recognized standards for optimal video performance and has
implemented a training program for technicians and installers to use these standards
to obtain optimal picture quality from Runco video display devices. Accordingly, Runco
recommends that setup and calibration be performed by an ISF certified installation
technician.
All signal types require separate processing. Therefore, you need to calibrate each
and every input separately.
To access the ISF Calibration menu, use the up- or down-arrow keys to highlight ISF
Calibration and press Enter. Use the number buttons on the remote control to enter
the ISF Calibration menu passcode, then press Enter again.
NOTE: You only need to enter the ISF Calibration menu passcode the first time you select
that menu after turning on the projector.
Runco CL-610
> Video
S-Video
Component1
Component2
RGB-HD
HDMI
------------------------
Aspect Ratio
Installation
Option
Setup

ISF Calibration

Reset Picture Adjust
Restore ISF Default.
Confirm?
No Yes
Runco CL-610 Owner's Operating Manual
Passcode
Please Enter
Passcode To
Access ISF
Calibration
Screen
* * *
To restore the ISF default image settings for the current input
source ONLY, press the ► arrow key to highlight "Yes" then
press Enter.
These settings are described in the "Picture Quality
Adjustments" section (refer to page 32).
These settings are described in the previous section, "Set
Up."
These settings are described in the previous section, "Set
Up."
This setting is described in the "Installation" section (refer
to page 35).
Passcode
Please Enter
Passcode To
Access ISF
Calibration
Screen
Confirmed
43
On-Screen Display Menus
ISF Calibration
➤ Reset Picture Adjust
➤ Picture Adjust
➤ White Balance
➤ Gamma Selection
➤ Blue Image