Removing The Bezel Assembly - Control Data Corporation CDC CC63X Hardware Maintenance Manual

I
.at'
-"
NOTE
Observe the positioning of the
actuator bar in the terminal
housing. Note the orientation of
the dog leg with respect to the
interlock switch mounted near the
rear panel.
2. Remove the two Allen head screws attaching the bezel
assembly to the bezel adapter assembly. Pull off the
BRIGHTNESS 'and CONTRAST knobs as shown in figure 6B-6.
Lift the bottom edge of the bezel assembly slightly, pull
it down, and then lift it away from the terminal.
3. Remove touchpanel if installed (procedure 19).
4. Remove the .POWER switch rocker from its socket as follows:
---.
a. With right hand pull back and hold power actuator bar
toward rear of cabinet enclosure.
b. Then, with left hand, pull rocker straight up while
rotating it 180
0
while pulling.
UlJ!f'
>
i::. ~--~--.
' - . . .
~-­
KNOBS
POWER
ACTUATOR
BAR
BEZEL ADAPTER
ASSEMBLY
POWE R SWITCH
ROCKER
04344-2
Figure 6B-6. Removing the Bezel Assembly
6B-lO
62940034 F
1"-""
/
I,