Procedure 11 -Removing And Replacing Power Actuator Bar - Control Data Corporation CDC CC63X Hardware Maintenance Manual

I
I
12. Replace logic drawer assembly (procedure 4, steps 6
through 13).
13. Re-enter terminal and mode installation parameters into
NVM (information on entering parameters is contained in
the manuals listed in preface).
LOGIC DRAWER
- (BACK PANEL}
PUSH REAR PORTION OF
TAB TOWARD CENTER OF
MAIN LOGIC BOARD
MOVE MAIN LOGIC BOARD
FORWARD AND DOWN TO
04346
REMOVE FROM MTG. RACK
Figure 6B-ll. Removing Main Logic Board
Procedure 11 -Removing and Replacing Power Actuator Bar
Remove and replace the power actuator bar as follows:
1. Remove the bezel -adapter assembly (procedure 5, steps 1
through 4).
2. Remove the actuator bar and spring from its socket.
3. Install a replacement actuator bar in position.
4. Reassemble the terminal with instructions in procedure 5,
steps 13 through 17.
6B-l8
62940034 F
',-,
-'
'"
(--,
i
I
""