Table of Contents
Advertisement
2
ZSSC415x/6x/7x Evaluation Board
2.1.
Overview
Note: See section 2.2 for the SSC EB schematic, including pin names for the CB (Bu1) and SRB (K10) connectors.
Figure 2.1 ZSSC415x/6x/7x SSC Evaluation Board – Overview
Table 2.1
ZSSC415x/6x/7x Evaluation Board Connectors, Switches, and LEDs
Name
D1
Status LED for the KS5V supply. Its forward current is not included in the measured supply current.
Bu1
50-pin female connector connected to the SSC CB. See section 2.3 for descriptions of the signals on Bu1.
K10
50-pin male connector to the SRB. See section 2.4 for descriptions of the signals on K10.
KL1
On-board screw terminal for GND (VSSE), VDDE2 (to VDDE), VDDA, and TS1 connections.
KL2
On-board screw terminal for TS2, VSSA, TOP, and BR2P (not applicable to ZSSC4151).
KL3
On-board screw terminal for BR2N (not applicable), BR1P (to BRP), BR1N (to BRN), and BOT.
K1, K9
Powers (enables) the headers for connecting external Sensor 1 or Sensor 2 modules (K2 and K5 respectively) via KS5V.
K2, K5
Headers for connections for external Sensor 1 or Sensor 2 modules.
K4, K6
Strips for access to all ZSSC4151 signals; can be used to connect directly to the ZSSC4151 for in-circuit programming.
K7
Connects KS5V supply to VDDE pin (leave open when external power supply VDDE2 is connected); provides test points
for simple supply current measurements.
K8
onnects the external SRB temperature sensor to the IC's TS1 or TS2 inputs.
C
S1
Switch that is used for interface selection during programming and calibration (set to OWI for ZSSC4151 IC).
QFN-24
Socket for inserting the QFN 4x4mm ZSSC4151 DUT.
K11
Mass Calibration Board (MCB) DUT connector.
© 2016 Integrated Device Technology, Inc.
ZSSC4151 Evaluation Kit Hardware Manual
Description
5
March 11, 2016
Advertisement
Table of Contents
