Setup; Required Or Recommended User Equipment; Kit Hardware Connections; Figure 1. Evaluation Kit Setup Using The P9242-R-Evk Mm Evaluation Board As The Transmitter - IDT P9221-R-EVK User Manual

1. Setup

1.1 Required or Recommended User Equipment

The following additional lab equipment is required for using the kit:
P9242-R-EVK MM Evaluation Board or any WPC-1.2 compliant transmitter

Power supply or 12V/2A AC adaptor


1.2 Kit Hardware Connections

Follow these procedures to set up the kit as shown in Figure 1:
1. Set up the P9242-R-EVK Evaluation Board (or user transmitter) according to the board's user manual.
2. Place the P9221-R-EVK on the transmitter (TX) pad with the components facing up as shown in Figure 1.
3. Verify that the green LEDs on both boards are illuminated indicating that coupling has been established.
4. Connect wires to the VOUT and GND test points to measure the output voltage and apply a load.
Figure 1. Evaluation Kit Setup using the P9242-R-EVK MM Evaluation Board as the Transmitter
P9242-R-EVK
Green LEDs illuminate when
connection has been established.
© 2017 Integrated Device Technology, Inc.
P9221-R-EVK Evaluation Board User Manual
Transmitter Coil
P9221-R-EVK
4 December 18, 2017